Proceedings
Authors
| Filter results5 paper(s) found. |
|---|
1. Site Specific Drip FertigationTwo test plots, one from high fertility zone and one from low fertility zone were identified and delineated with the help of GPS for raising the test crop. Soil samples were collected from the experimental sites one month before planting. The samples were analyzed for available N, P and K. Site specific nutrient recommendations were made using the Decision Support System for Integrated Fertilizer Recommendation (DSSIFER) software (Murugappan et al. 2004) for optimum yield.... A.H. V.m. |
2. Development of Real-time Color Analysis for the On- Line Automated Weeding OperationsWeeds compete with the crop for water, light, nutrients and space, and therefore reduce crop yields and also affect the efficient use of machinery. Chemical sprayer is the most popular method to eradicate weeds but has cause hazardous to the environment, crops and workers. A smart sprayer is required to control the usage of chemical weedicides at the optimal level. Thus an on-line automated sprayer is introduced to the Malaysian farmers to locate in the real time environment the existence and... W. Wan ismail, K. Abdul rahman |
3. Variety Effects on Cotton Yield Monitor CalibrationWhile modern grain yield monitors are able to harvest variety and hybrid trials without imposing bias, cotton yield monitors are affected by varietal properties. With planters capable of site-specific planting of multiple varieties, it is essential to better understand cotton yield monitor calibration. Large-plot field experiments were conducted with two southeast Missouri cotton producers to compare yield monitor-estimated weights and observed weights in replicated variety trials. Two replications... E. Vories, A. Jones, G. Stevens, C. Meeks |
4. Design and Performance Experiment of an Outer Grooved-Wheel Fertilizer Apparatus with the Helical ToothTraditional outer groove-wheel fertilizer apparatus (OGWFA) with the straight tooth exists the problem of breakage and pulsation in the fertilizing process. A new type of OGWFA with the helical tooth has been designed to solve this problem, and the amount of fertilizer can be adjusted. The helix angle of the helical tooth has been optimized by theory analysis and DEM simulation. It reveals that the helix angle should be ranged from 34.4° to 68.8°. The performances of the OGWFA with the... D. Jun, X. Junfang, Z. Wangyuan, W. Qiaohua, D. Youchun, S. Caixia, Z. Zhihui |
5. Impact of Cover Crop and Soil Apparent Electrical Conductivity on Cotton Development and YieldCotton is one of the major crops in the New Madrid Seismic Zone (NMSZ) of the U.S. Lower Mississippi River Valley region. Because cotton production doesn’t leave a lot of crop residue in the field, low soil organic matter levels are common. While the benefits of crop rotation are well known, cotton is often grown year after year in the same fields for economic reasons. Soils in the region are generally quite variable, with areas of very high sand content. Winter cover crops and reduced tillage... E. Vories, K. Veum, K. Sudduth |