Authors
| Filter results8 paper(s) found. |
|---|
1. Development Of A System For Site-specific Nematicide Placement In CottonNematode distribution varies significantly in cotton fields. Population density throughout a field is highly correlated to soil texture. Field-wide application of a uniform nematicide rate results in the chemical being applied to areas without nematodes or where nematode densities are below an economic threshold, or the application of sub-effective levels in areas with high nematode densities. The investigators have developed a “Site- Specific Nematicide Placement”... A. Khalilian, W. Henderson, J. Mueller, T. Kirkpatrick, S. Monfort, C. Overstreet |
2. Spatial Mapping Of Penetrometer Resistance On Turfgrass Soils For Site-specific CultivationSite-specific management requires site-specific information. Soil compaction at field capacity is a major stress on recreational turfgrass sites that requires frequent cultivation. Spatial mapping of penetrometer... K. Rice, T. Carson, J. Krum, I. Flitcroft, V. Cline, R. Carrow |
3. Tools For Evaluating The Potential Of Automatic Section ControlOne of the newest technologies in precision agriculture is automatic section control on application equipment. This technology has tremendous potential to reduce wasted inputs, especially on irregularly shaped fields. Paybacks are not necessarily as great on rectangular fields. Producers considering adoption of the technology need to decide whether they will receive sufficient payback for their field shapes. They must also decide... T. Stombaugh, R.S. Zandonadi, J.D. Luck, T.P. Mcdonald, T. Mcgraw |
4. Assembly of an Ultrasound Sensors System for Mapping of Sugar Cane HeightIn Precision Agriculture, the use of sensors provides faster data collection on plant, soil, and climate, allowing collecting larger sample sets with better information quality. The objective of this study was the development of a system for plant height measurement in order to mapping of sugar cane crop, so that regions with plant growth variation and grow failures could be identified... A.H. Garcia, F.H. Rodrigues júnior, A.H. Bastos, P.S. Magalhaes, M.J. Silva |
5. CANopen Implementation To Wireless Sensor NetworkField buses are widely applied in the control of mobile machines. They enable us to build embedded control systems, where the sensors and actuators are connected to each other by the bus. The most commonly used bus standard for Control Area Network (CAN) between tractors and implements in agriculture and forestry is ISOBUS. Once the number of sensors and actuators increases in the implement side, a combination of ISOBUS and CANopen can be applied. CANopen is a communication protocol... R. Virrankoski, M. Madetoja |
6. Utilizing Space-based Technology for Cotton Irrigation SchedulingAccurate soil moisture content measurements are vital to precision irrigation management. Electromagnetic sensors such as capacitance and time domain reflectometry have been widely used for measuring soil moisture content for decades. However, to estimate average soil moisture content over a large area, a number of ground-based in-situ sensors would need to be installed, which would be expensive and labor intensive. Remote sensing using the microwave spectrum (such as GPS signals) has been used... A. Khalilian, X. Qiao, J.O. Payero, J.M. Maja, C.V. Privette, Y.J. Han |
7. Data Fusion of Imagery from Different Satellites for Global and Daily Crop MonitoringSatellite-based Crop Monitoring is an important tool for decision making of irrigation, fertilization, crop protection, damage assessment and more. To allow crop monitoring worldwide, on a daily basis, data fusion of images taken by different satellites is required. So far, most researches on data fusion focus on retrospective analysis, while advanced crop monitoring capabilities mandate the use of data in real time mode. Therefore, our project goals were: (1) to build a data-fusion online system... O. Beeri, R. Pelta, S. Mey-tal, J. Raz |
8. Designated Value for a Field Polygon Based on Imagery Data: A Case Study of Crop Vigor in Agricultural Application for IrrigationAny irrigation action for a field management zone, which is based on images, requires a transformation into single value. Since data distribution is ab-normal in an image, using a mean value to estimate the crop coefficient (Kc), an overlaid polygon may not represent properly its water demand. Therefore, this project’s aim was to examine to which extent different statistics of potential designated values will affect an estimated Kc, and consequently affect irrigation practices. Satellite... R. Rud, O. Beeri, S. Mey-tal |