Authors
| Filter results10 paper(s) found. |
|---|
1. Study on Monitoring System of Wheat SowingIn order to real-time monitoring the sowing status of the multi-channel seeder, a distributed monitoring system is developed. The monitoring module of sowing and the monitoring terminal is designed with ... W. Fu, Z. Meng, G. Wu, J. Dong, H. Mei, C. Zhao |
2. Adoption and Non-Adoption of Precision Farming Technologies by Cotton FarmersWe used the 2009 Southern Cotton Precision Farming Survey data collected from farmers in twelve U.S. states (Alabama, Arkansas, Florida, Georgia, Louisiana, Missouri, Mississippi, North Carolina, South Carolina, Tennessee, Texas, and Virginia) to identify reasons on why some adopt and others do not adopt precision farming techniques. Those farmers who provided the cost as the reason for non-adoption are farmers characterized by lower education... A.K. Mishra, M. Pandit, K.P. Paudel, E. Segarra |
3. The Spatial And Temporal Variability Analysis Of Wheat Yield in suburban of BeijingAbstract: The yield map is the basis of the fertilization maps and plant maps. In order to diagnose the cause of variation accurately, not only the spatial variation of annual yield data, but also the successive annual yield data of temporal variability should be understood.The introduction of yield monitor system, global positioning system (GPS), and geographic information system have provided new methods to obtain wheat yield in precision agriculture.... Z. Meng, Z. Wang, G. Wu, W. Fu, X. An |
4. The Device of Air-assisted Side Deep Precision Fertilization for Rice TransplanterRice is the most important crop in China, which has the largest plant area. Fertilization is an important process of rice production, which directly affects the yield of crops, reasonable and effective use of chemical fertilizer can improve the yield of crops. At present, the mechanization level of rice fertilization is very low in China, and the artificial fertilization requires a large amount of fertilizer which caused the uneven distribution. The rice side deep fertilizing is an ideal way of... C. Zhao, G. Wu, Z. Meng, W. Fu, L. Li, X. Wei |
5. Development of Land Leveling Equipment Based on GNSSAn attitude adjustable land leveling equipment was designed. The reference elevation of the land to be leveled was generated based on the topographic data which was acquired by the RTK-GNSS technology. The blade lifting mechanism was controlled by comparing the reference elevation and the real-time blade’s elevation and attitude data which was obtained by the dual antenna GNSS receiver and as a result the land leveling operation was implemented. A new algorithm using the electro-hydraulic... W. Fu, G. Wu, H. Bao, X. Wei, Z. Meng |
6. An Automatic Control Method Research for 9YG-1.2 Large Round BalerWhen manual or semi-automatic round baler working, the tractor driver have to frequently manual the machine according to the bale process at the same time of driving. The driver easily feel fatigue in this operating mode for a long time, so the consistency of the bale’s density can not be guaranteed. And there may be wrong operation. In this article, we use the model 9YG-1.2 large round baler as a research prototype. We study the information collection and processing of the baler’s... J. Dong, Z. Meng, Y. Cong, A. Zhang, W. Fu, R. Pan, Q. Yang, Y. Shang |
7. Development of Farmland-Terrain Simulation System for Consistency of Seeding DepthA farmland-terrain simulation system suitable for rugged topography was designed to study the irregularities of farmland surface morphology led by both topographic fluctuation and terrain tilt. The system consists of terrain simulation mechanism, hydraulic system, control system, etc. The terrain simulation mechanism is connected to the rack through hydraulic cylinder to simulate farmland surface fluctuation. The hydraulic system controls the hydraulic cylinder to drive the terrain simulation... W. Fu, J. Dong, Y. Cong, N. Gao, Y. Li, Z. Meng |
8. Opportunities for Precision Agriculture in SerbiaThe aim of this paper is to analyze the factors leading to low adoption rate of precision farming in Serbia and to describe steps being taken by BioSense institute to increase it. The majority of the arable land in Serbia is grown by small family owned and operated farms most of which are in the range of 2 to 5 ha making them highly unsustainable. Only 16% of the arable land is managed by agricultural companies and cooperatives. We believe that the adoption of advanced technologies with the currently... A.C. Tagarakis, F. Van evert, D. Milic, V. Crnojevic, V. Crnojevic-bengin, C. Kempenaar, N. Ljubicic |
9. How Digital is Agriculture in South America? Adoption and LimitationsA rapidly growing population in a context of land and water scarcity, and climate change has driven an increase in healthy, nutritious, and affordable food demand while maintaining the current cropping area. Digital agriculture (DA) can contribute solutions to meet the demands in an efficient and sustainable way. South America (SA) is one of the main grain and protein producers in the world but the status of DA in the region is unknown. This article presents the results from a systematic review... G. Balboa, L. Puntel, R. Melchiori, R. Ortega, G. Tiscornia, E. Bolfe, A. Roel, F. Scaramuzza, S. Best, A. Berger, D. Hansel, D. Palacios |
10. Overcoming Educational Barriers for Precision Agriculture Adoption: a University Diploma in Precision Agriculture in ArgentinaThe lack of educational programs in Precision Agriculture (PA) has been reported as one of the barriers for adoption. Our goal was to improve professional competence in PA through education in crop variability, management, and effective practices of PA in real cases. In the last 20 years different efforts has been made in Argentina to increase adoption of PA. The Universidad Nacional de Rio Cuarto (UNRC) launched in 2021 the first University Diploma in PA, a 9-month program to train agronomist... G. Balboa, A. Degioanni, R. Bongiovanni, R. Melchiori, C. Cerliani, F. Scaramuzza, M. Bongiovanni, J. Gonzalez, M. Balzarini, H. Videla, S. Amin, G. Esposito |