Authors
| Filter results9 paper(s) found. |
|---|
1. Mepiquat Chloride Application On Cotton At Variable RateMepiquat chloride (1,1-dimethylpiperidinium chloride) are used to control excessive vegetative growth in cotton (Gossypium hirsutum L.) broadcast sprayed by ground or air. As proven by previous researches the variability of the cotton plants height in the field is large enough to justify the application of Mepiquat at variable rate. The major advantages of it are: (i) yield increase; (ii) economy of the applied input; (iii) reducing the potential of environmental pollution. The main objective... P.S. Magalhaes, , |
2. A Comparison Of Spectral Reflectance And Laser-induced Cholorphyll Fluorescence Measurements To Detect Differences In Aerial Dry Weight And Nitrogen Update Of WheatChlorophyll fluorescence and spectral reflectance analysis are both powerful tools to study the spatial and temporal heterogeneity of plants` biomass and nitrogen status. Whereas reflectance techniques have intensively been tested for their use in precision fertilizer application, laser-induced chlorophyll fluorescence has been tested to a lesser degree, and there are hardly any... B. Mistele, U. Schmidhalter |
3. Active Sensor Performance – Dependence to Measuring Height, Light Intensity and Device TemperatureFor land use management, agriculture, and crop management spectral remote sensing is widely used. Ground-based sensing is particularly advantageous allowing to directly link on-site spectral information with agronomic algorithms. Sensors are nowadays most frequently used in site-specific oriented applications of fertilizers, but similarly site-specific applications of growth regulators, herbicides and pesticides become more often adopted. Generally little is known about the effects of... B. Mistele, U. Schmidhalter, S. Kipp |
4. Comparison of Active and Passive Spectral Sensors in Discriminating Biomass Parameters and Nitrogen Status in Wheat CultivarsSeveral sensor systems are available for ground-based remote sensing in crops. Vegetation indices of multiple active and passive sensors have seldom been compared in determining plant health. This study was aimed to compare active and passive sensing systems in terms of their ability to recognize agronomic parameters. One bi-directional passive radiometer (BDR) and three active sensors (Crop Circle, GreenSeeker, and an active flash sensor (AFS)) were tested for their ability to assess six destructively... B. Mistele, U. Schmidhalter, K. Erdle |
5. Optimizing Path Planning By Avoiding Short Corner Tracks... J.P. Molin, M. Spekken |
6. A Comparison of Plant Temperatures as Measured By Thermal Imaging and Infrared Thermometry... P. Baresel, B. Mistele, H. Yuncai, U. Schmidhalter, H. Hackl |
7. Landscape Influences on Soil Nitrogen Supply and Water Holding Capacity for Irrigated Corn... T. Shaver, M. Schmer, S. Irmak, S. Van donk, B. Wienhold, V. Jin, A. Bereuter, D. Francis, D. Rudnick, N. Ward, L. Hendrickson, R. Ferguson, V.I. Adamchuk |
8. Assessing Water Status in Wheat under Field Conditions Using Laser-Induced Chlorophyll Fluorescence and Hyperspectral MeasurementsClassical measurements for estimating water status in plants using oven drying or pressure chambers are tedious and time-consuming. In the field, changes in radiation conditions may further influence the measurements and thus require... S. El-sayed, U. Schmidhalter, B. Mistele |
9. Measuring And Mapping Sugarcane GapsSugarcane is an important crop in tropical regions of the world and especially for Brazil, the largest sugar supplier in the market, also running a domestic fleet of flex-fuel driven vehicles based on ethanol. Site specific production management can impact sugarcane production by increasing yield and reducing cost. Sugarcane fields are planted each five years, in average, and an important parameter that is measured after the planting operation is the gaps caused by problems during planting... J.P. Veiga, D.S. Cavalcante, J.P. Molin |